How to allow Windows 98 to connect to QNAP NAS?

How to allow Windows 98 to connect to QNAP NAS?

Last modified date: 2017-03-20

Applied Models:

All NAS Series

Answer:

Connect the Turbo NAS via ssh (port 22, enabled by default) or telnet (port 13131, disabled by default) and add the command below to Global section of smb.conf under /mnt/HDA_ROOT/.config by vi command.
lanman auth = yes
client lanman auth = yes
Run the following commands to copy settings and restart samba.
# cp /mnt/HDA_ROOT/.config/smb.conf /etc/default_config/
# /etc/init.d/smb.sh restart
Enter the web administration page and select [Access Right Management] > [Users] > select the users that will use Windows 98 to connect the NAS and click [Change Password].
Input the password for the Windows 98 users and click OK.
Login to Windows 98 with the same username/password on the Turbo NAS.
Users can connect to the NAS through Windows 98 now.

NOTE:

YOU MUST PERFORM STEP 3 AND STEP 4 TO RECONFIGURE THE PASSWORD EVEN IF YOU DO NOT WANT TO CHANGE THE PASSWORD.
You need to repeat step 2 to 4 if you want to create a new user account or change password.

Was this article helpful?

Yes. No.

50% of people think it helps.

For further assistance, ask other users and QNAP experts in the community. Go to QNAP Community

Please tell us how this article can be improved:

The article is missing important information
The article's solutions do not work
The article is too complicated
The article contains incorrect information
The article is out-of-date

If you want to provide additional feedback, please include it below.

If you want to provide additional feedback, please include it below.