I would like to set the system for only alarm (motion) recordings. How do I disable continuously recording?

Last modified date: 2022-03-30

Applied products:

VioStor NVR, Surveillance Station and QVR Pro

Applied firmware:

All QVR and QTS

Scenarios:

I would like to set the system for only alarm (motion) recordings. How do I not continuously record? In Event Management I have checked the "Enable Alarm Recording" box. How do I disable continuous recording?

Solution:

On the VioStor NVR and Surveillance Station, you can refer to the picture below to disable the “schedule recording” option.

Then the “alarm recording option” and “when motion is detected” options must be enabled, you will get the alarm (motion) recording only.

On QVR Pro, you can disable all streams (if have) of Normal Recording. Then enable the stream option of Event Recording and add an event rule in Event Management.

Was this article helpful?

Yes. No.

29% of people think it helps.

For further assistance, ask other users and QNAP experts in the community. Go to QNAP Community

Please tell us how this article can be improved:

The article is missing important information
The article's solutions do not work
The article is too complicated
The article contains incorrect information
The article is out-of-date

If you want to provide additional feedback, please include it below.