Upgrade/flash the NAS firmware without disks installed
Data da última modificação:
2024-10-14
Applicable Products:
- All NAS series
Procedure
- Please follow this method to find the NAS model and download the firmware of your NAS.
- Power-off the NAS and remove all the disks then boot the NAS up with no disks installed. Important: Please make a note about the drive order, you will have to plug them back in in the same order.
- Wait for a short beep and a long beep from the NAS.
- Install and launch Qfinder to locate the NAS. Important: press No,when Qfinder Pro prompts you with this message.
- Find Tools > Update firmware
- Insert the default password of admin.
Note: Password of admin is the first MAC address of NAS in uppercase letters and without special characters.
- Select the firmware downloaded from step 1.
- The warning message may pop up, select Yes to proceed.
- Wait for the procedure finished and NAS reboots
- Firmware is upgraded/flashed.
