[Fontos biztonsági figyelmeztetés] Hamis Qfinder Pro weboldalakat észleltünk. Tudjon meg többet >

My RAID is in degraded read-only mode. What should I do?


Release date: 2026-10-17

Applicable Product

  • All QNAP NAS models

Scenario

One day, I could not write data into my shared folder and I found my RAID becomes read-only mode. What can I do?


Solution

If a RAID is in degraded read-only mode, it means more than the allowed number of drives have failed and the RAID can’t be rebuilt even if you replace the faulty drives.

RAID Configuration

The Maximum Number of Drives Allowed to Fail

RAID 5

1

RAID 6

2

RAID 10

2

The RAID pool and volumes will be put in read-only mode by the system to stop any accidental data corruption. The data should be backed up to another location as soon as possible. Please follow the steps as below:

1.Backup all the data stored on the faulty RAID.
Suggest to copy out the data by SMB by File Explorer in Windows or AFP by Finder in OSX or setup External Drive Backup in Hybrid Backup Sync. 
If the above methods don’t work, please install and use WinSCP in Windows see if you can copy the files out through SSH. If this still doesn’t work, please help to open a ticket by QNAP Service Portal.


2. After backup is finished, remove the volumes and/or pool on the faulty RAID volume.
Note: All data will be removed, make sure the data has been backed up.

3.Replace all the faulty HDDs.

4.Create a new RAID on storage pool or static volume

5.Restore the data to the new volume.

 

Was this article helpful?

37% of people think it helps.
Thank you for your feedback.

Továbbra is segítségre van szüksége?

Tegye fel kérdését a QNAP közösségben. A QNAP munkatársai és tapasztalt felhasználók válaszolnak.

Kérdezze meg a közösséget

Please tell us how this article can be improved:

If you want to provide additional feedback, please include it below.

Válassza ki a specifikációt

      Mutass többet Kevesebb
      Ez a webhely más országokban / régiókban:
      back to top