[Fontos biztonsági figyelmeztetés] Hamis Qfinder Pro weboldalakat észleltünk. Tudjon meg többet >

10GBase-T Network card install position

Release date: 2022-06-24

Applied models:

All NAS Series

Applied Firmware:

4.4.3

If you received your NAS, for example a TS-H1283XU-RP-128G. And you found a 10Gbase-T NIC has been installed on slot 2.

According to QNAP website, 10Gbase-T nic was on slot 3.

You do not need to change it, according to the specification of the NAS, the card can be mounted in both ports without any problem, so there is no need for correction.

Also if you leave the card in slot 2 it should be better ventilated because of the space between the cards, but it should work properly in both of them.

Was this article helpful?

Yes. No.

100% of people think it helps.

További segítségért kérdezze meg a többi felhasználót és a QNAP szakértőit a közösségben. Irány a QNAP közösség

Please tell us how this article can be improved:

The article is missing important information
The article's solutions do not work
The article is too complicated
The article contains incorrect information
The article is out-of-date

If you want to provide additional feedback, please include it below.

If you want to provide additional feedback, please include it below.