[Önemli Güvenlik Uyarısı] Sahte Qfinder Pro Web Siteleri Tespit Edildi. Daha fazla bilgi edinin >

How can I configure trunk mode on a managed switch?

Last modified date: 2023-02-13

Applicable Products

QSW-M2106-4C
QSW-M2106-4S
QSW-M2106PR-2S2T
QSW-M2106R-2S2T
QSW-M408-4C
QSW-M408-2C
QSW-M408S
QSW-M1208-8C
QSW-M1204-4C
QSW-M804-4C
QSW-M5216-1T
QSW-IM1200-8C
QSW-M2108-2C
QSW-M2108-2S
QSW-M2108R-2C
QSW-M2116P-2T2S

Overview

By default, all QSW managed switches operate using access mode. You can use the trunk mode when you want a switch to carry traffic for several VLANs simultaneously.

By tagging two or more VLANs to a LAN port, allowing the switch to carry traffic of multiple VLANs over a single link.

Procedure

Log in to QSS.
Go to Configuration > VLAN.
Click .
Select ports to include in the VLAN.
Note
You must enable two or more tagged port to enable trunk mode on a LAN port.
Click Save.

Further Reading

What is the default management mode on a managed switch?

Was this article helpful?

Yes. No.

14% of people think it helps.

Daha fazla yardım için toplulukta diğer kullanıcılara ve QNAP uzmanlarına sorun. QNAP Topluluğuna Git

Please tell us how this article can be improved:

The article is missing important information
The article's solutions do not work
The article is too complicated
The article contains incorrect information
The article is out-of-date

If you want to provide additional feedback, please include it below.

If you want to provide additional feedback, please include it below.