QVS not Support Virtual Switch with NAT/DHCP Enabled
Applied models:
-
All NAS Series
Applied Firmware:
-
4.4.1 or above
When creating a new Virtual Machine in Virtualization Station, you may encounter situations where it asks you to "Create a Virtual Switch" even though they are already created. This is likely due to the existing virtual switches have NAT/DHCP enabled.
Virtualization Station does not support virtual switch with NAT/DHCP functions. When creating a new Virtual Machine, it cannot detect the existing NAT/DHCP enabled virtual switch and so would prompt to create a new virtual switch. In this case, you could create a new virtual switch as prompt, and ensure NAT/DHCP is not enabled, or disable NAT/DHCP on the existing virtual switches and then create the virtual switch again, this should allow you to use the existing virtual switches successfully
Para obter mais ajuda, pergunte a outros utilizadores e aos especialistas da QNAP na comunidade. Ir para a Comunidade QNAP
