10GBase-T Network card install position
최신 업데이트일:
2022-06-24
Applied models:
Applied Firmware:
If you received your NAS, for example a TS-H1283XU-RP-128G. And you found a 10Gbase-T NIC has been installed on slot 2.
According to QNAP website, 10Gbase-T nic was on slot 3.
You do not need to change it, according to the specification of the NAS, the card can be mounted in both ports without any problem, so there is no need for correction.
Also if you leave the card in slot 2 it should be better ventilated because of the space between the cards, but it should work properly in both of them.
추가 도움이 필요하시면 커뮤니티에서 다른 사용자 및 QNAP 전문가에게 문의해 보세요. QNAP 커뮤니티로 이동
