What to do if I do not know the HDDs orders when migrating drives to a new NAS?

Release date: 2022-06-24

Applied Products:

QTS 4.3.6 or newer

If you created your RAID in firmware version 4.3.6 or newer, the HDD order does not matter. Plug all HDD in the NAS, power on the NAS, and it will detect the RAID normally.

Do note, if the RAID is created before the above version or you are not sure which version they are created on, the drive order would matter and is recommended to mark the drive orders before unplugging from the old unit, otherwise the RAID may not assemble successfully.

Was this article helpful?

Yes. No.

71% of people think it helps.

Please tell us how this article can be improved:

The article is missing important information
The article's solutions do not work
The article is too complicated
The article contains incorrect information
The article is out-of-date

If you want to provide additional feedback, please include it below.

If you want to provide additional feedback, please include it below.