After install QuFirewall i am not able to access the NAS
Applied models:
Applied Firmware:
-
4.5.1
After installing QuFirewall, you lost complete access to the NAS. In this case you will need to reset your NAS network setting. To do this, press the reset button on the rear side of your NAS for 3 seconds. Please release the button after you hear a beep. The following settings will be reset to default:
• System administration password: Will the MAC address of the First lan in Capital letter and without spaces (for example, if the MAC address is "24-5E-BE-18-3A-0E", the password will be 245EBE183A0E).
• TCP/IP configuration: Obtain IP address settings automatically via DHCP.
• TCP/IP configuration: Disable Jumbo Frame.
• TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port trunking mode will be reset to “Active Backup (Failover)”.
• System port: 8080 (system service port).
• Security level: Low (Allow all connections).
• LCD panel password: (blank)*.
• VLAN will be disabled.
• Service binding: All NAS services run on all available network interfaces.
• QuFirewall will be stopped and you will recover the NAS access to edit the firewall rules.
*This feature is only provided by the NAS models with LCD panels. Please visit http://www.qnap.com for details.
