[重要なセキュリティのお知らせ] 偽の Qfinder Pro ウェブサイトが検出されました。もっと見る >

How should I optimize advanced settings to cater to different usage scenarios?


最終更新日: 2018-03-02

On the "High Availability" page, click the “Cluster option" button to fine tune takeover and giveback behavior modes.

System failover protection: Takeover is automatically executed when the system detects that one of the controllers is abnormal. The default setting is “Enabled”.

Failover when network fails: Takeover is automatically executed when the system detects that one of the network connections is disconnected (if Port-Trunking is configured, then both connections must be disconnected). The default setting is “Disabled”.

Failover when JBOD fails: Takeover is automatically executed when the system detects that JBOD connection is interrupted. The default setting is “Enabled”.

Automatically failback when system recovers: Giveback is automatically performed when the system detects that a failed controller has returned to its normal state, and the startup and network connections were successful. The default setting is “Enabled”.

Prevent fail-back repeatedly: To avoid Takeover-Giveback loops due to hardware errors, enable this option to stop automatic giveback attempts after two Takeover-Giveback cycles. The default setting is “Enabled”.

Management port failover: The IP address of the Management-port will be transferred to the target controller during Takeover. If the Management-port is set to DHCP you will not be able to enable this option. The default setting is “Disabled”.

Users can customize High Availability settings to cater to different usage scenarios.

この記事は役に立ちましたか?

ご意見をいただき、ありがとうございます。

まだ解決しませんか?

QNAP コミュニティに質問を投稿してください。QNAP スタッフや経験豊富なユーザーが回答します。

コミュニティで質問する

この記事の改善箇所をお知らせください。

その他のフィードバックがある場合は、以下に入力してください。

仕様を選択

      もっと見る 閉じる
      当ページを他の国/地域で見る:
      back to top