How to reset network & virtual switch setting via command line
Ultima data di modifica
2021-08-24
Applicable Products:
- QTS 4.3.4 or older
Important: After running the procedres,the following takes place
- Reset all Ethernet interfaces to DHCP
- Remove any port trunking,
- Set LAN1 as the default gateway.
- Initialize QuFirewall setting
-
login QTS as admin and open App Center.
-
In App center, remove the following applications if installed.
- Remove QuFirewall
- Remove Linux Station
- Remove Container Station
- Remove Virtualization Station
-
SSH access the NAS and run the following commands.
# /mnt/ext/opt/netmgr/netmgr.sh reset_all_settings_to_default<br /> # /etc/init.d/network.sh reset_network_config_to_default<br /> # /etc/init.d/network.sh clean-restart<br /> # reboot -
After NAS reboots, login QTS as admin and open App center.
-
Install Container Station, open Container Station and setup folder setting
-
Install Linux Station and do the Ubuntu installation
-
Install QuFirewall
