When unplugging a hard disk (HDD) from the Turbo NAS, the NAS will freeze.

Release date: 2017-03-20

Applied Models:

All NAS Series

Answer:

Cause:
This is a QTS design limitation. When QTS is initiated, it sets a SWAP partition in the Turbo NAS HDD. It means that removing a HDD will cause unpredictable system behavior, including freezing and crashes.

Solution:
If your Turbo NAS is set to RAID 1, RAID 5 or higher, it can tolerate the removal of a single HDD. But if your Turbo NAS only has a single HDD or is set to RAID 0 or JBOD, you will encounter system freezing or crashes and the only way to recover is by reinserting the HDD and restarting the Turbo NAS.

Was this article helpful?

Yes. No.

83% of people think it helps.

További segítségért kérdezze meg a többi felhasználót és a QNAP szakértőit a közösségben. Irány a QNAP közösség

Please tell us how this article can be improved:

The article is missing important information
The article's solutions do not work
The article is too complicated
The article contains incorrect information
The article is out-of-date

If you want to provide additional feedback, please include it below.