QNAP Systems, Inc. - almacenamiento conectado en red (NAS)

Language

Support

After installing QM2 card into my TVS-871, my NAS is not able to boot and hangs at “System Booting”. How can I solve it?
To solve this issue, you need to update the BIOS. Please follow below steps to update the BIOS of your TVS-871.
 
1. Preparation:
  • Download package from below link:
 
2. Update BIOS
  • Extract the downloaded file and upload below 2 files to shared folder, “Public”
flashrom and QW56IR14.bin
  • Run below commands to perform the BIOS update
[~] # cd /share/Public
[/share/Public] # chmod +x flashrom
[/share/Public] #./flashrom -c MX25L12805D --programmer internal -w QW56IR14.bin

 

After successfully executing these commands you should see:

flashrom v0.9.9-unknown on Linux 4.2.8 (x86_64)
flashrom is free software, get the source code at https://flashrom.org
Calibrating delay loop... OK.
   :
   :
   :
Reading old flash chip contents... done.
Erasing and writing flash chip... Erase/write done.
Verifying flash... VERIFIED.

Once it's done, initiate a system reboot by the following command:
 
[/share/Public] # reboot
 
3. After the NAS reboot, check BIOS version again with the following commands:
 
[~] # dmidecode -s bios-version
QW56IR14
 
4. Done.
Fecha de lanzamiento: 2017-09-22
¿Le ha sido útil?
Gracias por sus comentarios.
Gracias por sus comentarios. Si tiene alguna pregunta, póngase en contacto con support@qnap.com
El 100% de las personas piensa que ayuda.