QNAP, Inc. - Network Attached Storage (NAS)



Why does my quick installation page show nothing?

Applied Models:


Please follow the procedure below to solve this problem.

  1. Power off the Turbo NAS.
  2. Remove all HDDs.
  3. Power on.
  4. System will make 1 short beep when you power on, and then after 2~4mins it will make a 2nd long beep.
  5. After the 2nd long beep, please plug in the HDD in sequence, ex: HDD1 --> slot 1, HDD2 --> slot2....etc.
  6. Please run the QNAP Finder and double click on the Turbo NAS unit.
  7. Keep following the quick installation setup.
Release date: 2013-04-19
Was it helpful?
Thank you for your feedback.
Thank you for your feedback. If you have any question, please contact support@qnap.com