QNAP, Inc. - Network Attached Storage (NAS)



I set Netbak Replicator to auto-connect when booting up, but sometimes, it failed to connect automatically.

Applied Models:


If you can’t connect to the QNAP Turbo NAS automatically, please check the settings below:

  1. Make sure that Netbak Replicator is not blocked by firewall or antivirus programs. If it is, please unblock it.
  2. Make sure there are no other network drives connected to the same Turbo NAS. If there are, please disconnect them and run Netbak Replicator again.
  3. Make sure the Turbo NAS is set to use DHCP and please set a static IP for the Turbo NAS.
  4. Make sure that the account ID and password have not been modified, and please reconnect to the Turbo NAS again.
Release date: 2013-12-04
Was it helpful?
Thank you for your feedback.
Thank you for your feedback. If you have any question, please contact support@qnap.com