After login on QTS system, it keeps displaying in blue and always shows “loading”

Last modified date: 2025-06-11

Applicable Products

QTS

Scenario

After logging in to QTS login page, the system would hang in the blue “loading” screen.

Solution

You could try performing the following steps to regain access:

Clear the cache of the browser.
Log in to the NAS via SSH and enter the 2 commands:
mv /etc/config/.qos_config /etc/config/.qos_config.old
/etc/init.d/thttpd.sh restart
If the volume is full, connect to the NAS via SMB and remove some files.

Once done, refresh the browser and login again.

Was this article helpful?

Yes. No.

16% of people think it helps.

Please tell us how this article can be improved:

The article is missing important information
The article's solutions do not work
The article is too complicated
The article contains incorrect information
The article is out-of-date

If you want to provide additional feedback, please include it below.

If you want to provide additional feedback, please include it below.