[Important Security Notice] Fake Qfinder Pro Websites Detected. Learn more >

Can I enable QSAL on an existing storage pool?


Last modified date: 2023-10-31

Applicable Products

QuTS hero


Answer

The ability to enable QNAP SSD Antiwear Leveling (QSAL) on an existing storage pool depends on the QuTS hero version running on your NAS:

Firmware VersionCan I Enable QSAL on an Existing Storage Pool?
QuTS hero h4.5.2–h5.0.1No.
QSAL can only be enabled when creating a new storage pool and cannot be disabled later.
QuTS hero h5.1.0 or laterYes.
You can enable or disable QSAL on a storage pool at any time.

To enable or disable QSAL on an existing storage pool in QuTS hero h5.1.0 or later, follow these steps:

  1. Open Storage & Snapshots.
  2. Go to Storage > Storage/Snapshots.
  3. Select a storage pool.
    Note

    To enable QSAL on a storage pool, the pool must contain a RAID group that meets the following requirements:

    • The RAID group must be one of the following RAID types: RAID 5, 6, 50, 60, TP.
    • The RAID group must contain at least two SSDs that can provide estimated life remaining.
    • At least one SSD in the RAID group must have over 3% estimated life remaining.
  4. Click Manage.
    The storage pool management window opens.
  5. Click QSAL.
    This tab only appears if the storage pool contains a RAID group that meets the requirements for QSAL.
  6. Optional: Select a different RAID group. 
  7. Click the toggle button to enable or disable QSAL.
  8. Click Close.

Further Reading

How do I enable QSAL?

Was this article helpful?

Thank you for your feedback.

Still need help?

Post your question in QNAP Community. QNAP staff and experienced users will reply.

Ask the Community

Please tell us how this article can be improved:

If you want to provide additional feedback, please include it below.

Choose specification

      Show more Less
      Choose Your Country or Region
      back to top