[Important Security Notice] Fake Qfinder Pro Websites Detected. Learn more >

Q: I didn’t see the RAID type selection in SSD Cache acceleration function in QuTS Hero, is this normal?


Last modified date: 2022-03-30

Q: I didn’t see the RAID type selection in SSD Cache acceleration function in QuTS Hero, is this normal?

 

A:  Yes, this is normal. In QuTS Hero, only Cache Type can be selected in Cache acceleration setup.

 

Depending on the number of SSD and Cache types selected, the system will set up different RAID types accordingly. Please refer to the table below.

 

The number of  SSD

Read Cache

Read Cache and ZIL synchronous I/O Write log (Read cache +  Write Cache)

1

Single disk

Not Support

2

Stripe (RAID 0)

Stripe (RAID 0) + Mirror (RAID 1)

3

Stripe (RAID 0)

Not Support

4

Stripe (RAID 0)

Stripe (RAID 0) + Stripe of mirrors (RAID 10)

     
     

 

If the cache type is set to Read Cache and ZIL synchronous I/O Write log, you must select an even number of disks.

 

Read cache will set up a RAID 0 with the third disk partition on each disk ,the size of the third partition is similar to the whole disk size.

ZIL synchronous I/O Write log will set up a RAID 1 or RAID 10  by 2 or 4/6/8 or more disks with the sixth disk partition on each disk. the size of the sixth partition is fixed to 10TB.

 

For example: if 2 x 450GB SSDs are set up with Read Cache and ZIL synchronous I/O Write log.

Read cache is around 2 x 422GB in RAID 0 = 844.52 GB.

ZIL synchronous I/O Write log is 2 x 10GB in RAID 1 = 10GB

Was this article helpful?

100% of people think it helps.
Thank you for your feedback.

Still need help?

Post your question in QNAP Community. QNAP staff and experienced users will reply.

Ask the Community

Please tell us how this article can be improved:

If you want to provide additional feedback, please include it below.

Choose specification

      Show more Less
      Choose Your Country or Region
      back to top