FAQ

How to reset network & virtual switch setting via command line

Last modified date: 2021-08-24

Applicable Products:

QTS 4.3.4 or older

Important: After running the procedres,the following takes place

Reset all Ethernet interfaces to DHCP
Remove any port trunking,
Set LAN1 as the default gateway.
Initialize QuFirewall setting

login QTS as admin and open App Center.
In App center, remove the following applications if installed.
- Remove QuFirewall
- Remove Linux Station
- Remove Container Station
- Remove Virtualization Station
SSH access the NAS and run the following commands.

# /mnt/ext/opt/netmgr/netmgr.sh reset_all_settings_to_default<br /> # /etc/init.d/network.sh reset_network_config_to_default<br /> # /etc/init.d/network.sh clean-restart<br /> # reboot
After NAS reboots, login QTS as admin and open App center.
Install Container Station, open Container Station and setup folder setting
Install Linux Station and do the Ubuntu installation
Install QuFirewall

Was this article helpful?

Yes. No.

52% of people think it helps.

Please tell us how this article can be improved:

The article is missing important information
The article's solutions do not work
The article is too complicated
The article contains incorrect information
The article is out-of-date

If you want to provide additional feedback, please include it below.

If you want to provide additional feedback, please include it below.